Picture
Picture Picture

Your first remedy when the message above appears should be to check that the base station cable is properly connected at both ends.

If this message would appear in the middle of the game you should unplug the cable a couple of seconds and then plug it in again.

If reconnecting the USB cable does not help, please close Bridge Scorer Control and restart the program.

FIRST USAGE
If the above message would be displayed the first time you start the control software after installation, then you should suspect that the USB drivers were not properly installed. So, please run the setup again and make sure that BridgeScorer drivers are ticked.

Previously installed drivers
If the message shown to the right would appear during setup (when you are trying to fix the problem with a Base Station that does not connect), then you have to uninstall the faulty drivers before you can (again) run setup with the BridgeScorer drivers option ticked.

Uninstall drivers can be done with Windows Add or Remove Programs tool that you find you find in the Control Panel (via Windows Start).

Picture
Picture

PROBLEMS PERSIST
See the No communication page if problems would persist.

 

Index