Results shows all results achieved at the table and it also gives you possibility to change them and to enter the most common rulings.

Records  shows the results in chronological order, which is useful if you want to study exactly what happened at the table.

Set section and table no. hard codes these parameters so that the players do not have to enter table number at the start of every session.

You are advised to to preset table numbers when two clubs run games in parallel, i.e. when not all Scorers use the same channel. This is so because you will run into unnecessary problems if Scorers that are set to different channels are mixed up. You should mark the plastic housing of the Scorers, when you have preset the table no.

The section/table that has been set is shown on the START screen (before start). You can remove a hard coded table no. by confirming (OK) a blank section/table entry.

Recover and Replace are explained on a separate page.

 Channel need to be changed when:

1. Separate games (e.g. when two clubs share premises)
2. The  radio link is disturbed by other wireless devices, e.g. wireless LANs, c.f. the page dealing with communication problems.

The channel setting must be the same in the Control Software and the table unit.

Install is used to upgrade the firmware in the unit, c.f. memo on the subject.

New game shall ONLY be used when a Scorer has been left in an unfinished state and you want  to force it to its Start position.

Current game must be used when you want to resume an ongoing game.

Note that there is no need to panic if you in a stressful moment would press New game instead of Current game. You can rescue the situation with the Recover option

Index